Appendix D: Serial Port and Telnet Commands
Superuser Commands
SmartBits 600x/6000x Installation Guide | 123
CARDS SHOW – Displays the status of each slot in the system as well as the user
information for any cards currently shared or reserved.
CARDS ENABLE|DISABLE [cardlist] – Enables or disables all access to the card(s) in
cardlist. Users currently reserving or sharing these cards will not have their access affected
until they unreserve or stop sharing the card, after which they will be affected as any other
user.
CARDS RESET [cardlist] – Issues a warm boot command to each card in the cardlist.
Note: IPFW commands only work with TeraMetrics modules.
IPFW SET [ip][card][port][user] – Assigns the IP Address to the card.
IPFW CLEAR [ip] – Removes the address definitions.
IPFW SHOW – Returns to the list of current IP Addresses.
SYNC STATUS/ABORT – (SyncOps are multi-chassis tests.) Allows for the inquiry of
the status of the SyncOps or to abort the operation.
ETR MODE/STATUS/TIME/DATE/FFOM/TFOM – See “ETR Commands” on page
126.
ETH SET – Allows the user to set the speed and duplex of the chassis controller’s (host)
Ethernet port. The value for speed can be 10, 100, or Auto; indicating 10 Mbps, 100 Mbps,
or autonegotiable. The value for duplex can be half, full or Auto; indicating half duplex,
full duplex, or autonegotiate.
REBOOT – Issues a warm boot command to each card in the cardlist.
INITFLASH – Resets the chassis to its default settings.
SUPASS – Provides a mechanism to alter the Super User password. First, the current
password must be correctly entered at the prompt Please enter Super-user password:. If
not correctly entered, an error string “Incorrect Super-user password” is displayed. Then
the prompt Please enter new Super-user password: for the new password is displayed.
This password must be entered twice and must be exactly eight characters. Once a new
password is entered, it will be encrypted and stored in a non-volatile Flash RAM. The user
is prompted again Please re-enter new Super-user password: to confirm the new
password. If a mismatch is detected, the error string “The new passwords are not same.
Existing Super-user password will not be changed.” is displayed, and the change is
rejected.
EXITSU – Exits superuser mode and exits access to the superuser command set.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...