SPX FLOW 030-U3 - Install Seal O-Ring; Install Rotary Seal Components

Maintenance Waukesha Cherry-Burrell
®
Brand Universal 3 Pump
Page 74 95-03103 11/2018
3. Install the body retaining screws. Lubricate the thread with
food-grade anti-seize. Lightly hand-tighten the screws, so the
pump body is securely seated against the gear case.
Install Seal O-ring
NOTE: Do not lubricate the seal O-ring.
1. For a single O-ring seal, install the seal O-ring in the front
groove in the seal housing.
2. For a double O-ring seal, install the back O-ring first, then
install the front O-ring. The O-rings fit into the grooves in the
seal housing.
Install Rotary Seal Components
1. Lubricate and install the sleeve front O-ring on the rotor.
Figure 170 - Install body retaining
screws
Figure 171 - Install seal O-ring
Figure 172 - Install sleeve front O-ring