Page 46 | Stellar
®
AutoTarper Owner’s Manual
Chapter 3 - Operation
General Operation
Safety should be the n umber one thought on every operator’s mind. Three factors should
exist for safe operation: a qualied operator, well-maintained equipment, and the proper
use of this equipment.
This chapter contains information regarding the safety and operation the Stellar®
AutoTarper and should be read and understood completely by everyone working with or
near the AutoTarper before putting the unit into operation.
Failure to follow operating, maintenance, or safety instructions can result
in death or serious injury.
It is the responsibility of the owner to instruct the operator in the safe operation of the
equipment and to provide the operator with properly maintained equipment.
Stellar
®
AutoTarper operators must conform to the qualications
specied in this manual. Trainees or untrained persons shall be under the direct supervision
of qualied persons.
Operators shall consult with the owner of the equipment regarding current safety
regulations and required personal protective equipment.
Operators should never operate the AutoTarper while under the adverse inuence of
alcohol, drugs, or medication.
Please take note that Stellar Industries, Inc. is not liable for accidents incurred by the
AutoTarper because of non-fulllment from the operator’s side of current rules, laws, and
regulations.
Operation is limited to the following people:
A. Qualied individual.
B. Trainees under direct supervision of the qualied individual.
C. Test or maintenance individual.
D. AutoTarper Inspector.
Qualied individuals must:
A. Demonstrate the ability to understand all decals, the owner’s manual, and any other
information required for safe operation of the AutoTarper.
B. Be able to demonstrate the ability to safely control the AutoTarper.
C. Know all safety regulations.
D. Be responsible for maintenance requirements.
E. Understand and be fully capable of implementing all emergency procedures.
F. Understand all operating procedures as outlined by this manual.
Operator Requirements