Suspension configuration
You can define up to 10 new user-defined suspensions.
Hint
Configure all-in-one suspensions as lubricants. If they are configured as
suspensions, the dosing level will not be high enough.
1. From the Configuration menu, select Suspension configuration.
2. In the Suspension name column you can select an item. You can rename or
delete this item.
3. Select the corresponding field in the Abr. type column.
4. Select the abrasive type. Make sure that you select the correct type.
You can choose between:
– Diamond
– Oxide
5. To return to the Configuration menu, press Back
Lubricant configuration
You can define up to 10 new user-defined lubricants.
Hint
Configure all-in-one suspensions as lubricants. If they are configured as
suspensions, the dosing level will not be high enough.
1. From the Configuration menu, select Lubricant configuration.
2. In the Lubricant name column you can select an item. You can rename or
delete this item.
3. Select the corresponding field in the Lubricant type column.
4. Select the lubricant type. Make sure that you select the correct type.
– 1 DP-Lubricant, water based
Select this option if the lubricant contains water.
– 2 DP-Lubricant, alcohol based
Select this option if the lubricant is water-free and is to be used for
preparing water-sensitive materials.
5. To return to the Configuration menu, press Back
6 Operating the device
AbraPol-30 29
To Next Page