The specimen holder returns to its initial position.
6.6.4 The Spin function
Only use the spin function to rotate the preparation disc at high speed
• to remove water from the surface of the disc.
• to remove water from an MD-Disc or a SiC Foil/SiC Paper before you remove it,
• to dry an MD-Disc or an MD-Chem cloth
Procedure
At 100 rpm
1. To start the spin function, press the Disc rotation button. It rotates at 100 rpm.
2. To stop the spin function, press the Disc rotation button again.
At 150 rpm
1. To start the spin function, press and hold the Disc rotation button. It rotates at
150 rpm.
2. To stop the spin function, press the Disc rotation button again.
At 600 rpm
1. Close the cover of the machine.
2. To start the spin function, press and hold the Disc rotation button. It rotates at
600 rpm.
3. To stop the spin function, release the Disc rotation button.
7 Maintenance and service -
AbraPol-30
Proper maintenance is required to achieve the maximum up-time and operating lifetime of the
machine. Maintenance is important in ensuring continued safe operation of your machine.
The maintenance procedures described in this section must be carried out by skilled or trained
personnel.
7 Maintenance and service - AbraPol-30
AbraPol-30 39
To Next Page