Struers AbraPol-30 - Options

6.3.5 Options
From the Options menu you set up general options for e.g. display, language, disc size, etc.
• If needed, you can reset some settings to their factory default value:
Press function key F1 when the value is highlighted.
Option Setting
Display brightness You can adjust the display to make it easier to view.
Language Select the language you wish to use in the software.
Keyboard sound • Yes:
Whenyou press a button on the control panel, a sound is heard.
• No:
Nosoundis heard.
Units Show the removal rate settings in one of the following units:
• Newton - µm (Metric)
• Lbf - mils (Imperial)
Select disc size Select the disc size diameter:
• 300 mm
• 350 mm
Date Set the date.
Time Set the time
Operation mode See Operation mode ►26.
Auto continue mode You can set the machine to automatically continue to the next step in
a method, as long as the consumables used are the same.
Setting Definition
Off The machine pauses between
each step.
Equal cons. except SiC The machine automatically
continues to the next step, but
pauses when grinding with SiC
Paper, which must be changed
between the steps.
Always The machine automatically
continues to the next step.
Flushing time after OP
step
20 - 60 seconds
30 AbraPol-30
6 Operating the device