14. The machine must be disconnected from the electrical power supply prior to any service. Wait 5
minutes until residual potential on the capacitors is discharged.
15. Do not switch the machine on and off more than once every five minutes. Damage to the
electrical components could occur.
16. In case of fire, alert bystanders and the fire brigade. Disconnect the electrical power supply. Use
a powder fire extinguisher.Do not use water.
17. Struers equipment must only be used in connection with and as described in the instruction
manual supplied with the equipment.
18. The equipment is designed to be used only with Struers consumables specifically designed for
this purpose and this type of machine.
19. Dismantling of any part of the equipment, during service or repair, should always be performed
by a qualified technician (electromechanical, electronic, mechanical, pneumatic, etc.).
2.2 Safety messages
Signs used in safety messages
Struers uses the following signs to indicate potential hazards.
ELECTRICAL HAZARD
This sign indicates an electrical hazard which, if not avoided, will result in death or
serious injury.
DANGER
This sign indicates a hazard with a high level of risk which, if not avoided, will result in
death or serious injury.
WARNING
This sign indicates a hazard with a medium level of risk which, if not avoided, could
result in death or serious injury.
CAUTION
This sign indicates a hazard with a low level of risk which, if not avoided, could result
in minor or moderate injury.
CRUSHING HAZARD
This sign indicates a crushing hazard which, if not avoided, could result in minor,
moderate or serious injury.
General messages
Note
This sign indicates that there is a risk of damage to property, or a need to proceed
with special care.
8 AbraPol-30
2 Safety
To Next Page
Loading...
