34 EN
Figure 16: Arthroscopy Pump voice commands interface on monitor
Sidne™ Feedback Messages
Sidne™ Says Meaning
“Arthroscopy
pump...”
Added as a prefix to the messages below when the control is issued from the
tablet or pump front panel while not in the arthroscopy voice-command menu.
“Stopped” The pump was stopped by voice, tablet, or front-panel command.
“Activated” The pump was activated by voice, tablet, or front-panel command.
“Wash mode off” The wash mode was stopped by voice, tablet, or front-panel command.
“Wash mode
selected”
The wash mode was activated by voice, tablet, or front-panel command.
“Knee joint
selected”
Knee-joint preset settings were selected by voice, tablet, or front-panel
command.
“Shoulder joint
selected”
Shoulder-joint preset settings were selected by voice, tablet, or front-panel
command.
“Small joint
selected”
Small-joint preset settings were selected by voice, tablet, or front-panel
command.
“Error” The pump error indicator on the pump front panel is illuminated.
“Tubing not
inserted”
The pump detects that the tubing is not inserted when an “activate” command is
given by voice, tablet, or front-panel command.
“Overpressure” The pump detects an overpressure condition.
To Next Page
Loading...
