Stryker Sidne - Page 49

44 EN
Voice Commands Menu
Awaken
Device
Select
Control Select Description
Sidne™ Shaver
Clear Error (Hidden
Command)
Clears the pending TPS console error
message.
Handpiece
Next Port
Selects the handpiece connected to the
next port.
Endo
Selects the handpiece connected to the
Endo port.
TPS 1
Selects the handpiece connected to the
TPS 1 port.
TPS 2
Selects the handpiece connected to the
TPS 2 port.
Oscillate Activate
Starts the handpiece motor at the preset
speed in the Oscillate mode.
Forward
Activate
Starts the handpiece motor at the preset
speed in the Forward mode.
High
Sets the Endo handpiece speed to high
range.
Low
Sets the Endo handpiece speed to low
range.
Reverse
Activate
Starts the handpiece motor at the preset
speed in the reverse mode.
High
Sets the Endo handpiece speed to high
range.
Low
Sets the Endo handpiece speed to low
range.
Preset
Up Increases the handpiece preset speed.
Down Reduces the handpiece preset speed.
High Sets the handpiece speed to high range.
Low Sets the handpiece speed to low range.
Stop Stops the handpiece motor.
Stop Stops the handpiece motor.