CRANKSHAFT POSITION SENSOR
I
FUEL INJECTION (FUEL SYSTEMS)
5.
Crankshaft Position Sensor
B: INSTALLATION
A:
REMOVAL
1)
Disconnect the battery ground cable.
Install in the reverse order of removal.
Tightening torque:
T: 6.4
N.m
(0.65
kgf-m,
4.7 ff-lb)
2) Remove the bolt which install the crankshaft po-
sition sensor
to
cylinder block.
3)
Remove the crankshaft position sensor, and dis-
connect the connector from it.
FU(D0HC TURBO)-30
To Next Page
Loading...
