FUEL SUB LEVEL SENSOR
FUEL INJECTION (FUEL
SYSTEMS)
27.Fuel Sub Level Sensor
A:
REMOVAL
WARNING:
Place “NO
FIRE”
signs near the working area.
Be careful not to
spill
fuel on the floor.
1)
Disconnect the battery ground cable.
2)
Lift-up the vehicle.
3)
Drain the fuel from the fuel tank. Set a container
under the vehicle and remove drain plug from fuel
tank.
4) Tighten the fuel drain plug.
Tightening torque:
26
N.m
(2.65 kgf-m, 79.2
ft-lb)
5)
Remove the rear seat.
6)
Remove the service hole cover.
G2M0863
/
7)
Disconnect the connector from the fuel
meter.
8)
Disconnect the fuel jet pump hose.
//
/
S2M0151
sub
9)
Remove the bolts which install the fuel sub meter
unit on fuel tank.
10)
Remove the fuel sub meter unit.
\
FU(D0HC TURBO)-63