CLEAR MEMORY MODE
ENGINE
(DIAGNOSTICS)
13.Clear Memory Mode
A:
OPERATION
1.
SUBARU SELECT MONITOR (NORMAL
MODE)
1)
On the ((Main Menu)) display screen, select the
(2.
Each System Check} and press the [YES] key.
2)
On the ((System Selection Menu)) display
screen, select the {Engine Control System} and
press the [YES] key.
3)
Press the [YES] key after displayed the informa-
tion of engine type.
4)
On the ((Engine Diagnosis,) display screen, se-
lect the {Clear Memory} and press the [YES] key.
5)
When the 'Done' and 'Turn Ignition Switch OFF'
are shown on the display screen, turn the Subaru
Select Monitor and ignition switch
to
OFF.
NOTE:
For detailed operation procedure, refer to the
UAL.
2.
SUBARU SELECT MONITOR (OBD
MODE)
1)
On the ((Main Menu,) display screen, select the
(2.
Each System Check} and press the [YES] key.
2)
On the &ystem Selection Menu), display
screen, select the {Engine Control System} and
press the [YES] key.
3)
Press the [YES] key after displayed the informa-
tion of engine type.
4)
On the (<Engine Diagnosis,, display screen, se-
lect the {OBD System} and press the [YES] key.
5)
On the (<OBD Menu)) display screen, select the
(4.
Diagnosis Code(s) Cleared} and press the
[YES] key.
6)
When the 'Clear Diagnostic Code?' is shown on
the display screen, press the [YES] key.
7)
Turn the Subaru Select Monitor and ignition
switch
to
OFF.
NOTE:
For detailed operation procedure, refer to the
UAL.
3.
OBD-II GENERAL SCAN TOOL
SUBARU SELECT
MONITOR
OPERATION MAN-
SUBARU SELECT MONITOR OPERATION MAN-
For clear memory procedures using the OBD-II
general scan tool, refer to the OBD-II General Scan
Tool
Instruction Manual.
EN(D0HC
TURBO)-49
To Next Page
Loading...
Need help?
General
