IDLE AIR CONTROL SOLENOID VALVE
FUEL INJECTION (FUEL SYSTEMS)
11
.Idle
Air
Control Solenoid
Valve
A:
REMOVAL
1)
Disconnect the battery ground cable.
B:
INSTALLATION
Install in the reverse order of removal.
NOTE:
Always use a new gasket.
Tightening torque:
2.8
N-m
(0.29
kgf-m,
2.1
fWb)
2)
Disconnect the connector from the idle air con-
trol solenoid valve.
I
EN0822
3)
Remove the idle air control solenoid valve from
the throttle body.
I
4) Remove the gasket from throttle body.
FU( DOHC TU
RB0)-36
To Next Page
Loading...
