Subaru 2002 Impreza - Cylinder Block

iia
CYLINDER BLOCK
MECHANICAL
2O.Cylinder Block
A: REMOVAL
16) Remove the oil cooler.
NOTE:
Before conducting this procedure, drain the engine
oil completely
if applicable.
1) Remove the intake manifold. <Ref. to FU(D0HC
TURBO)-1
5, REMOVAL, Intake Manifold.>
2) Remove the V-belt. <Ref. to ME(D0HC TUR-
BO)-44, REMOVAL, V-belt.>
3) Remove the crankshaft pulley. <Ref. to
ME(D0HC TURBO)-46, REMOVAL, Crankshaft
Pulley.>
4) Remove the belt cover. <Ref. to ME(D0HC
TURBO)-47, REMOVAL, Belt Cover.>
5) Remove the timing belt assembly. <Ref. to
ME(D0HC TURBO)-48, REMOVAL, Timing Belt
Assembly
.>
6) Remove the camshaft sprocket. <Ref. to
ME(D0HC TURBO)-57, REMOVAL, Camshaft
Sprocket.>
7) Remove the crankshaft sprocket. <Ref. to
ME(D0HC TURBO)-58, REMOVAL, Crankshaft
Sprocket.>
8) Remove the generator and A/C compressor with
their brackets.
9) Remove the cylinder head assembly. <Ref. to
ME(D0HC TURBO)-64, REMOVAL, Cylinder
Head Assembly.>
10) Remove the clutch disc and cover. (MT vehi-
cles) <Ref. to CL-11, REMOVAL, Clutch Disc and
Cover.
>
11) Remove the flywheel. (MT vehicles) <Ref. to
CL-14, REMOVAL, Flywheel.>
12) Remove the drive plate. (AT vehicles)
Using the ST, lock crankshaft.
ST 498497100 CRANKSHAFT STOPPER
13)
14)
15)
I
Remove the oil separator cover.
Remove the water by-pass pipe for heater.
Remove the oil filter.
(a) Gasket
(b) Oil cooler
(c) Connector
17) Removal of oil pan:
(1) Turn the cylinder block with #2 and #4 piston
sides facing upward.
(2) Remove the bolts which secure oil pan to
cylinder block.
(3) Insert a oil pan cutter blade between cylin-
der block-to-oil pan clearance and remove the
oil pan.
CAUTION:
Do not use a screwdriver or similar tool in place
of oil pan cutter.
18) Remove the oil strainer stay.
19) Remove the oil strainer.
20) Remove the baffle plate.
21) Remove the water pipes.
22) Remove the water pump.
M E( DOH C TU R BO)-72