#a
PRESSURE SENSOR
FUEL INJECTION (FUEL
SYSTEMS)
1O.Pressure Sensor
A:
REMOVAL
1)
Disconnect the battery ground cable.
2)
Remove the idle air control solenoid valve. <Ref.
to
FU(D0HC TURBO)-36, REMOVAL, Idle Air
Control Solenoid Valve.>
3) Disconnect the connectors from pressure sen-
sor.
4)
Remove the pressure sensor from the throttle
body.
B:
INSTALLATION
Install in the reverse order of removal.
NOTE:
Replace the O-ring for the pressure sensor with
new ones.
Tightening torque:
1.6
N-m (0.16 kgf-m,
1.2
ft-16)
FU(D0HC TURBO)-35
To Next Page
Loading...
