DIAGNOSTIC PROCEDURE
WITH
DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Check
s
the value greater than
i
50°C
302”F)?
s
the value less than -40°C
(-
IO’F)?
Step
CHECK CURRENT DATA.
1
)Start the engine.
2)Read the data of engine coolant temperature
sensor signal using Subaru Select Monitor or
OBD-II general scan
tool.
NOTE:
*Subaru Select Monitor
For detailed operation procedure, refer
to
the
“READ CURRENT DATA FOR ENGINE”. <Ref.
to
EN(D0HC TURBO)-38, Subaru Select Mon-
itor.>
*OBD-ll general scan
tool
For detailed operation procedures, refer
to
the
OBD-ll General Scan Tool Instruction Manual.
Yes No
Go
to step
2.
Repair poor con-
tact.
NOTE:
In this case, repai
the following:
Poor contact in
engine coolant
temperature sen-
sor
Poor contact in
ECM
Poor contact in
coupling connect0
Poor contact in
joint connector
Replace the Repair ground
engine coolant short circuit in har.
temperature sen- ness between
sor. <Ref.
to
engine coolant
FU(D0HC temperature sen-
TURBO)-29, sor and ECM con-
Engine Coolant nector.
Temperature Sen-
CHECK HARNESS BETWEEN ENGINE
COOLANT TEMPERATURE SENSOR AND
ECM CONNECTOR.
1)Turn the ignition switch
to
OFF.
2)Disconnect the connector from engine cocl-
ant temperature sensor.
3)Turn the ignition switch
to
ON.
4)Read the data of engine coolant temperature
sensor signal using Subaru Select Monitor or
OBD-ll general scan
tool.
NOTE:
*Subaru Select Monitor
For detailed operation procedure, refer
to
the
“READ CURRENT DATA FOR ENGINE. <Ref.
to
EN(D0HC TURBO)-38, Subaru Select Mon-
itor.>
*OBD-ll general scan
tool
For detailed operation procedures, refer
to
the
OBD-ll General Scan Tool Instruction Manual.
sor.>
EN(D0HC
TURBO)-127
To Next Page