EasyManua.ls Logo

Subaru 2002 Impreza - Page 353

Subaru 2002 Impreza
598 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Step
Check Yes
1)Start the engine.
2)Read the data of engine coolant temperature
sensor signal using Subaru Select Monitor or
OBD-II general scan
tool.
NOTE:
OSubaru Select Monitor
For detailed operation procedure, refer to the
“READ CURRENT DATA
FOR
ENGINE”. <Ref.
to
EN(D0HC TURBO)-38, Subaru Select Mom
itor.>
*OBD-II general scan tool
For detailed operation procedures, refer to the
OBD-ll General Scan Tool Instruction Manual.
CHECK CURRENT DATA.
I
Is
the value less than -40°C
(-
40°F)?
I
Go to step
2.
!
CHECK HARNESS BETWEEN ENGINE
Is
the voltage more than 10
V?
No
Repair battery
Repair poor con-
tact.
NOTE:
In this case, repai
the following:
m
Poor contact in
engine coolant
temperature sen-
sor
*
Poor contact in
ECM
Poor contact in
coupling connect0
m
Poor contact in
joint connector
Go to step
3.
COOLANT TEMPERATURE SENSOR AND
ECM CONNECTOR.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from engine cool-
ant temperature sensor.
3)Measure the voltage between engine coolant
temperature sensor connector and engine
ground.
Connector
&
terminal
(E8)
No.
2
(+)
-
Engine ground
(-):
1
CHECK HARNESS BETWEEN ENGINE
COOLANT TEMPERATURE SENSOR AND
ECM CONNECTOR.
1)Turn the ignition switch to
ON.
2)Measure the voltage between engine coolant
temperature sensor connector and engine
ground.
Connector
&
terminal
(E8)
No.
2
(+)
-
Engine ground
(-):
I
CHECK HARNESS BETWEEN ENGINE
COOLANT TEMPERATURE SENSOR AND
Go
to step
4.
short circuit in har-
ness between
ECM and engine
coolant tempera-
ture sensor con-
nector.
Is
the voltage more than 10
V?
Repair battery
short circuit in har-
ness between
ECM and engine
coolant tempera-
ture sensor con-
nector.
Is
the voltage more than 4
V?
Go to step
5.
Repair harness
and connector.
NOTE:
In this case, repai
the following:
Open circuit in
harness between
ECM and engine
coolant tempera-
ture sensor con-
nector
Poor contact in
engine coolant
temperature sen-
sor connector
9
Poor contact in
ECM connector
Poor contact in
coupling connecta
Poor contact in
joint connector
EN(D0HC TURBO)-129

Table of Contents