FRONT OXYGEN (NF) SENSOR
FUEL INJECTION (FUEL SYSTEMS)
B: INSTALLATION
1)
Before installing front oxygen
(NF)
sensor, apply
the anti-seize compound only to the threaded por-
tion of front oxygen
(NF)
sensor to make the next
removal easier.
Anti-seize compound:
CAUTION:
Never apply anti-seize compound to protector
of front oxygen
(NF)
sensor.
2)
Install the front oxygen
(NF)
sensor.
Tightening
torque:
SS-30
by
JET
LUBE
21N.m
(2.1
kgf-m,
15.2
ff-lb)
I
I
I
3)
Install the service hole cover.
I
n
EN0832
4) Lower the vehicle.
5)
Install the front right side wheel.
6)
Connect the engine harness with clip
(A)
to the
bracket (B).
7)
Connect the connector of front oxygen
(NF)
sen-
sor.
8) Install the solenoid valve cover.
9)
Connect the battery ground cable.
FU(D0HC TURBO)-43
To Next Page
Loading...
