EasyManuals Logo

SunFounder ESP32 User Manual

Default Icon
771 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #241 background imageLoading...
Page #241 background image
SunFounder ESP32 Starter Kit
5. Choose the correct board (ESP32 Dev Module) and port, then click the Upload button.
6. Open the Serial monitor (set baud rate to 115200) and wait for a successful connection message.
7. After a successful connection, activating the switch in Blynk will start the PIR module’s surveillance. When
motion is detected (state of 1), it will say, “Somebody here!” and send an alert to your email.
1.52. 8.9 Blynk-based Intrusion Notification System 235

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SunFounder ESP32 and is the answer not in the manual?

SunFounder ESP32 Specifications

General IconGeneral
BrandSunFounder
ModelESP32
CategoryController
LanguageEnglish