EasyManua.ls Logo

Sungrow SH10RT - Page 162

Sungrow SH10RT
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
150
Parameters SH5.0RT-20 SH6.0RT-20
Peak output power on single
phase ****
2000 VA (≥9.6kWh) 2200 VA (≥12.8kWh)
Rated output current for
backup load during on grid
mode
3 x 18.5 A
* Depending on the connected battery.
** Germany is available for 2 inverters parallel in maximum if no ripple control is used in
system.
*** Can be reached only if PV and battery power is sufficient.Detail compatibility for backup
under off-grid scenario can be referred to the user manual.
**** Peak power only for Resistive loads. Detail refer to SHRT backup output power
document.
Parameters SH8.0RT-20 SH10RT-20
PV Input
Recommended max. PV in-
put power
12000 W 15000 W
Max. PV input voltage
1000 V 1000 V
Min. PV input voltage / Start-
up voltage
200 V / 250 V 200 V / 250 V
Rated input voltage
600 V 600 V
MPP voltage range
200 V - 950 V 200 V - 950 V
MPP voltage range for rated
power
330 V - 850 V 280 V - 850 V
No. of MPPTs 2
Max. number of PV strings
per MPPT
1 / 1
Max. PV input current 27 A (13.5 A / 13.5 A)
Max. current for input
connector
30 A
Short-circuit current of PV
input
36 A (18 A / 18 A)
54 A (18 A / 36 A)
Battery Data
Battery type Lithium battery
Battery voltage 150 V - 600 V
Max. charge / discharge
current
30 A */ 30 A *
Max. charge / discharge
power
10600 W / 10600 W 10600 W / 10600 W
11 Appendix User Manual

Table of Contents

Other manuals for Sungrow SH10RT

Related product manuals