72
figure 6-2 SUNCLIX Connector Components
1: Spring 2: Sleeve 3: Insert 4: Cable gland
step 1 Strip the insulation from the cable by 15 mm.
step 2 Pry the connection open and pull the sleeve and the insert apart.
step 3 Insert the stripped cable into the cable gland up to the stop. The stranded wire can be seen
inside the spring. Press the spring down until it audibly snaps into place.
step 4 Push the insert into the sleeve and tighten the cable gland (torque 2 N·m).
6 Electrical Connection User Manual
To Next Page
Loading...
