Risk of inverter damage or personal injury
Do not pull out PV connectors, AC connector or battery connectors
while the inverter is running. De-energize from all multiple power
sources. Wait 10 minutes for the internal capacitors to discharge. Verify
that there is no voltage or current before pulling any connector.
All the warning labels and nameplate on the inverter body:
must be clearly visible; and
must not be removed, covered or pasted.
Risk of burns due to hot components
Do not touch any hot parts (such as heat sink) during operation. Only
the LCD panel and the DC switch can safely be touched at any time.
Only qualified personnel can change the country setting.
Unauthorized alteration of the country setting may cause a breach of
the type-certificate marking.
Risk of inverter damage due to electrostatic discharge (ESD).
By touching the electronic components, you may damage the inverter.
For inverter handling, be sure to:
avoid any unnecessary touching; and
wear a grounding wristband before touching any connectors.
Batteries deliver electric power, resulting in burns or a fire hazard when
they are short circuited, or wrongly installed.
Lethal voltages are present in the battery terminals and cables in the
inverter. Severe injuries or death may occur if the cables and terminals
in the inverter are touched.
To Next Page
Loading...
