FUEL SYSTEM 5-11
FUEL INJECTOR / DELIVERY PIPE
REMOVAL
!
The components after the high pressure fuel pump re-
main pressurized at all times.
To protect against fuel spray, relieve fuel line pressure
before disconnecting or removing components.
(See the page 5-2.)
1. Remove the port side cover. (See the page 7-2.)
2. Loosen the clamp and place a large cloth over the end of the
fuel feed hose.
Slowly pull the fuel feed hose from the fuel delivery pipe.
Drain any excess fuel in the hose into a small container.
INSPECTION
See the page 3-39 to 3-41 for inspection of the fuel injector
operation.
3. Disconnect the four fuel injector connectors.
4. Remove the two bolts and the fuel delivery pipe (with the
fuel injectors).
#
A small amount of fuel may be released when the fuel
injector is removed from delivery pipe.
Place a shop cloth under fuel injector before removal
to absorb any fuel released.
Dispose of fuel soaked cloth in appropriate container.
5. Remove each injector from the delivery pipe.
To Next Page
