Suzuki DF 60 - Ptt Motor Relay

POWER TRIM AND TILT 8-17
PTT MOTOR RELAY
Two methods can be used to test the PTT motor relays.
Method 1.
Measure the resistance between the two lead wires of the relay.
$ 09930-99320: Digital tester
* Tester range:
ΩΩ
ΩΩ
Ω (Resistance)
Method 2.
1. Inspect the relay operation using a battery (12V) as follows:
$ 09930-99320: Digital tester
% Tester range:
&&
&&
& (Continuity)
(1) Without the lead wires connected to the battery, there should
be continuity between the terminals 1, 2 and 3 but should
be no continuity between the terminals 3 and 4.
(2) With the Black lead wire connected to the battery negative -
terminal and the Light blue (or Pink) lead wire connected to
the battery positive + terminal, there should be continuity
between the terminals 2, 3 and 4.
2. The relay is considered to be without defect if the continuity
test results are as stated the above.
PTT motor relay solenoid coil resistance: 3.0 – 4.5
ΩΩ
ΩΩ
Ω
Lbl(P)
CONT
1
2
3
4
Lbl(P)
B
12V BAT.
1
2
3
4
B
Tester probe connection
Red
++
++
+ Black
--
--
-
UP relay Light Blue Black
DOWN relay
Pink
Black
PTT motor relayPTT motor relay
B
Lbl(P)