POWER TRIM AND TILT 8-15
INSTALLATION
Installation is reverse order of removal with the special attention
to the following steps.
1. Lower the tilt rod to the full down position.
2. Apply the Water Resistant Grease to the tilt cylinder lower
shaft and the lower shaft bushing.
3. Install the bushings 1 and the cylinder lower shaft 2 to the
PTT unit.
( 99000-25160: Suzuki Water Resistant Grease
4. Place the PTT unit in position, then install the clamp bracket.
5. Tighten the clamp bracket shaft nut to the specified torque.
" Clamp bracket shaft nut: 43 N
.
m (4.3 kg-m, 31.0 lb-ft)
6. Tighten the lower shaft bolts 1, pre-coated with the thread
lock, to the specified torque.
) 99000-32050: Thread Lock “1342”
" Cylinder lower shaft bolt: 50 N
.
m (5.0 kg-m, 36.0 lb-ft)
7. Install the anode 2, then tighten the bolts securely.
To Next Page
Loading...
