POWER TRIM AND TILT 8-7
INSPECTION
Arrange all components on a clean sheet of paper.
NOTE:
Do not lay the PTT components out on a rag, as dirt or lint may
be transferred to these items which may cause possible sys-
tem operating problems.
NOTE:
If excessive wear, cracks, defective or other damage is found
on any component, replace component.
• Inspect the PTT pump case for cracks, nicks, stripped threads
and any other imperfections.
Replace if necessary.
• Inspect the cylinder cover for cracks, nicks or damage.
Replace if necessary.
• Inspect the cylinder cover seal for cuts, nicks or wear.
• Inspect the O-rings for cuts, nicks or tears.
O-r
ingO-ring
To Next Page
