POWER TRIM AND TILT 8-11
PTT MOTOR DISASSEMBLY
1. For correct assembly, scribe an alignment mark on the field
case and the brush holder.
2. Remove the tape from the PTT motor cables and the cable
protector tube, then slide the cable protector tube upward.
3. Remove the screw securing the motor cable holder 1, then
slide the motor cable holder and the grommets 2 out as
shown.
1
1
5. Slide the field case upward and away from the brush holder.
NOTE:
When separating the field case from the brush holder, proceed
by pushing the PTT motor cables into the brush holder side.
4. Remove the two screws 1 securing the field case to the brush
holder.
6. Disconnect the PTT motor cables from the brush holder.
7. Remove the armature from the field case.
Note the position of the O-ring encircling the brush holder.
To Next Page
