8-4 POWER TRIM AND TILT
POWER TRIM AND TILT UNIT
REMOVAL
1. Raise the engine to the full tilt position and the lower manual
tilt lock levers 1.
#
During the following procedures, the engine must be
firmly secured and its weight fully supported. (See right)
2. Remove the tilt rod snap ring 2 and push the tilt cylinder
upper shaft pin 3 out.
3. Lower the tilt rod to the full down position and disconnect the
battery cable.
4. Remove the silencer cover bolt and the fastening band.
5. Disconnect the PTT motor cable wire leads (Green, Blue)
from the PTT motor relays.
6. Remove the PTT motor cable from the engine lower cover.
To Next Page
