6-10 POWER UNIT
32. Install the engine hook as shown position.
33. Lift up and remove the power unit from the engine holder.
$ 11291-91850: Engine hook
01150-08207: Bolt
%
Never use the engine hook (part no. 11291-91850) when
lifting whole outboard motor. This hook must be used
only when removing or installing power unit.
BEFORE INSTALLATION
1. Remove the plug 1 with the gasket.
2. Drive the locking edges of the lock washer 2.
3. Remove the oil pump stopper 3 from the oil pan.
POWER UNIT INSTALLATION
1. Set the two dowel pins and the gasket.
2. Apply the grease to the drive shaft splines.
& 99000-25160: Suzuki Water Resistant Grease
3. Install the power unit to the engine holder.
NOTE:
Rotate the crankshaft to aid alignment of the drive shaft and the
crankshaft splines.
INSTALLATION
Installation is reverse order of removal with the special attention
to the following steps.
!
Do not re-use the gasket once removed. Always use a
new gasket.
To Next Page
