POWER UNIT 6-9
24. Remove the six bolts and cylinder head cover.
25. Disconnect the breather hose from cylinder head cover.
26. Loosen all valve adjusting lock nuts 1.
27. Loosen all valve adjusting screws 2 fully.
!
To prevent valve damage, loosen the valve adjusting lock
nuts and the valve adjusting screws fully before remov-
ing the timing belt.
28. Remove the three bolts and timing belt tensioner 1.
29. Remove the cam pulley bolt, then remove the timing belt
with the cam pulley. (See the page 2-12.)
30. Remove the side cover seal from the engine holder.
31. Remove the ten bolts and the two nuts.
To Next Page
