Suzuki DF 60 - Driveshaft Housing and Oil Pan

7-12 MID UNIT
DRIVESHAFT HOUSING AND OIL PAN
REMOVAL
1. Remove the power unit. (See the page 6-6 to 6-10.)
2. Remove the lower unit. (See the page 9-2.)
3. Remove the screw and the bonding wires from the driveshaft
housing.
4. Remove the screw 1 and the lower mount cover cap 2.
(Both sides)
5. Make sure that the pins 1 and springs 2 are installed on
lower mount cover 3. (Both sides)
6. Remove the four bolts and the lower mount cover 3. (Both
sides)
7. Remove the two lower mount nuts and the washers.
8. Remove the two upper mount nuts and the washers.