ENGINE CONTROL SYSTEM 3-33
CANCELLATION
Procedure
1. Turn the ignition key to the “ON” position.
2. Pull out the emergency stop switch plate 1.
3. Pull up the emergency stop switch knob 2 three times in 10
seconds. A short beep will be heard if the cancellation is suc-
cessfully finished.
4. Turn the ignition key to the “OFF” position.
5. Set the switch plate 1 in the original position.
NOTE:
• Canceling of the system activation is possible regardless of
whether or not the engine oil has been replaced. Once the
system has operated, however, Suzuki strongly recommends
that the engine oil be replaced before canceling the system
activation.
• Even if the engine oil has been replaced with the system not
operating, it is still necessary to perform the cancellation.
To Next Page
Loading...
