FUEL SYSTEM AND THROTTLE BODY 5-25
NOTE:
Make sure the throttle valve open or close smoothly.
• Align the boss
A of the STP sensor with the groove
B of the
ST valve shaft.
• Install the STP sensor.
• Tighten the STP sensor mounting screws.
$ 09930-11960: Torx wrench
' STP sensor mounting screw:
2.0 N·m (0.2 kgf-m, 1.5 lb-ft)
NOTE:
Make sure the ST valve open or close smoothly.
• Apply thin coat of the engine oil to the new fuel injector cush-
ion seal
0, and install it to the fuel injector.
"
• Install the O-ring
A to the fuel injector.
• Apply thin coat of the engine oil to the new O-ring
A.
Replace the cushion seal and O-ring with a new one.
PartShark.com
877-999-5686
To Next Page
Loading...
