5-24 FUEL SYSTEM AND THROTTLE BODY
• Install the spring
4 and fast idle link lever
5.
NOTE:
Make sure that the spring ends are hooked correctly.
• Install the washers
5,
6, spring washer
7 and nut
8.
NOTE:
The washer
5
is inserting in the axis certainly.
• Apply SUZUKI SUPER GREASE to the seal lips.
& 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the seal
9.
• Apply a small quantity of SUZUKI SUPER GREASE to the
shaft ends and seal lips.
& 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Turn the TP sensor counterclockwise and install the mounting
screws.
• Tighten the TP sensor mounting screws.
$ 09930-11950: Torx wrench
' TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
PartShark.com
877-999-5686
To Next Page
Loading...
