7-86 CHASSIS
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt “A”
3 with the bar until the pin end diameter
becomes the specified dimension.
% Pin end diameter specification
D
#
• Adjust the drive chain, after connecting it. ("2-21)
DID 5.5 – 5.8 mm (0.217 – 0.228 in)
* After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
* Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.
PartShark.com
877-999-5686
To Next Page
Loading...
