ENGINE 3-21
• Remove the rear cylinder head cover
4.
• Remove the dowel pin
5 and O-ring
6.
FRONT CAMSHAFTS
• Turn the crankshaft to bring the “F” line
A on generator rotor
to the index mark
B of the valve inspection hole and also to
bring the cams to the position as shown in illustration.
NOTE:
* At the above condition, the front cylinder is at TDC of com-
pression stroke.
* Before removing the camshafts, inspect the valve clearance.
(
!
2-8)
• Remove the cam chain guide
1.
PartShark.com
877-999-5686
To Next Page
Loading...
