Suzuki LT-Z250 - Page 177

CHASSIS 7-15
 Install the rear wheel hub and washer.
NOTE:
The convex side of the washer faces outside.
 Tighten the rear wheel hub nut to the specified torque.
" Rear wheel hub nut: 138 N•m (13.8 kgf-m, 99.9 lb-ft)
 Install the cotter pin into the rear axle as shown.
 Install the rear hub plate. (RH only)
 Install the rear wheel. (!Below)
$
FRONT WHEEL
 Tighten the front wheel set nuts to the specified torque.
" Front wheel set nut: 50 N•m (5.0 kgf-m, 36.0 lb-ft)
NOTE:
When installing the front wheel, make sure that the arrow
A on
the tire points in the direction of rotation.
REAR WHEEL
 Tighten the rear wheel set nuts to the specified torque.
" Rear wheel set nut: 50 N•m (5.0 kgf-m, 36.0 lb-ft)
NOTE:
When installing the rear wheel, make sure that the instruction
SIDE FACING OUTWARDS
B on the rear tire faces outwards.
INSIDE
Washer
OUTSIDE
Replace the removed cotter pin with a new one.
PartShark.com
877-999-5686