8-14 ELECTRICAL SYSTEM
ARMATURE COIL INSPECTION
Check for continuity between each segment, and between each
segment and the armature shaft using the multi circuit tester.
If there is no continuity between the segments or there is conti-
nuity between the segments and shaft, replace the armature
with a new one.
$ 09900-25008: Multi circuit tester set
, Tester knob indication: Continuity test (-)
OIL SEAL
Check the seal lip for damage or leakage. If any damages are
found, replace the starter motor with a new one.
STARTER MOTOR REASSEMBLY AND
REMOUNTING
Reassemble and remount the starter motor in the reverse order
of removal and disassembly. Pay attention to the following
points:
"
Apply SUZUKI SUPER GREASE to the lip of the oil seal.
. 99000-25030: SUZUKI SUPER GREASE A (USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
Apply a small quantity of SUZUKI MOLY PASTE to the arma-
ture shaft.
/ 99000-25140: SUZUKI MOLY PASTE
Replace the removed O-rings with new ones to pre-
vent oil leakage and moisture.
PartShark.com
877-999-5686
To Next Page
Loading...
