2-20 PERIODIC MAINTENANCE
CHASSIS BOLTS AND NUTS
Check that all chassis nuts and bolts are tightened to their specified torque. (Refer to page 2-21 and 2-22 for
the locations of the following nuts and bolts.)
Tighten initially at 1 month and every 3 months there-
after.
Item N•m kgf-m lb-ft
1 Handlebar clamp bolt 23 2.3 16.5
2 Steering shaft holder bolt 23 2.3 16.5
3 Steering shaft nut 49 4.9 35.5
4 Wishbone arm pivot bolt/nut (Upper and lower) 65 6.5 47.0
5 Wheel hub nut (Front) 65 6.5 47.0
6 Wheel hub nut (Rear) 138 13.8 99.9
7 Wheel set nut (Front and rear) 50 5.0 36.0
8 Steering knuckle nut (Upper and lower) 29 2.9 21.0
9 Front shock absorber mounting bolt/nut (Upper and
lower)
60 6.0 43.5
0 Tie rod end nut 29 2.9 21.0
A Tie rod lock nut 29 2.9 21.0
B Front brake air bleeder valve 6 0.6 4.4
C Front brake caliper mounting bolt 26 2.6 19.0
D Front brake pipe nut (Upper and lower) 16 1.6 11.6
E Front brake master cylinder mounting bolt 10 1.0 7.0
F Front brake hose union bolt (Upper and lower) 23 2.3 16.5
G Front brake disc plate mounting bolt 23 2.3 16.5
H Footrest bolt (M8) 26 2.6 19.0
I Footrest bolt (M10) 55 5.5 40.0
J Rear shock absorber mounting bolt/nut (Upper) 78 7.8 55.0
K Rear shock absorber mounting bolt/nut (Lower) 60 6.0 43.5
L Swingarm pivot bolt/nut 85 8.5 61.5
M Rear brake cam lever bolt/nut 11 1.1 8.0
N Rear brake panel mounting nut 60 6.0 43.5
O Rear brake pedal mounting bolt 11 1.1 8.0
P Rear axle housing set bolt/nut (RH) 60 6.0 43.5
Q Rear axle housing set bolt/nut (LH) 65 6.5 47.0
R Rear axle housing/final gear case bolt 65 6.5 47.0
PartShark.com
877-999-5686
To Next Page
Loading...
