ELECTRICAL SYSTEM 8-27
BATTERY
SPECIFICATIONS
a Anode plates
e Stopper
b Separator (fiberglass plate)
f Filter
c Cathode plates
g Terminal
d Upper cover breather
h Safety valve
INITIAL CHARGING
FILLING ELECTROLYTE
Remove the aluminum tape
1 sealing the battery electrolyte
filler holes
2.
Remove the caps
3.
NOTE:
* After filling the electrolyte completely, use the removed caps
3 as the sealing caps of the battery electrolyte filler holes.
* Do not remove or pierce the sealed portions
4 of the electro-
lyte container.
Insert the nozzles of the electrolyte container
5 into the bat-
tery electrolyte filler holes, holding the container firmly so that
it does not fall. Take a precaution not to allow any of the fluid
to spill.
Type designation YTX9-BS
Capacity 12 V, 28.8 kC (8 Ah)/10 HR
PartShark.com
877-999-5686
To Next Page
Loading...
