Suzuki LT-Z250 - Brake Disc Removal and Disassembly

7-24 CHASSIS
 Apply SUZUKI SILICONE GREASE to the brake caliper
holder slide pin.
* 99000-25100: SUZUKI SILICONE GREASE
 Install the pin
1, washer 2 and caliper holder 3 to the cali-
per.
 Apply THREAD LOCK SUPER to the pin
1.
+ 99000-32130: THREAD LOCK SUPER  1360
 Tighten the pin
1 to the specified torque.
" Caliper holder slide pin: 23 N•m (2.3 kgf-m, 16.5 lb-ft)
 Install the pads and spring to the caliper.
 Tighten the brake pad mounting pins
4, brake caliper mount-
ing bolts
5 and brake hose union bolt 6 to the specified
torque.
" Brake pad mounting pin: 18 N•m (1.8 kgf-m, 13.0 lb-ft)
Brake caliper mounting bolt:
26 N•m (2.6 kgf-m, 19.0 lb-ft)
Brake hose union bolt: 23 N•m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
tons all the way into the caliper.
$
BRAKE DISC REMOVAL AND
DISASSEMBLY
 Remove the front wheel hub. (!7-11)
 Remove the brake disc.
Bleed air from the system after reassembling the
brake caliper. (!2-16)
PartShark.com
877-999-5686