7-40 CHASSIS
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering stem in the reverse order
of removal and disassembly. Pay attention to the following
points:
STEERING SHAFT
Apply SUZUKI SUPER GREASE to the O-ring, dust seals and
steering shaft before remounting the steering shaft.
& 99000-25030: SUZUKI SUPER GREASE A (USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
Install the dust seal
1 to the steering shaft.
Install the new O-ring
2 and dust seal to the steering shaft.
Tighten the steering shaft nut to the specified torque.
" Steering shaft nut: 49 N•m (4.9 kgf-m, 35.5 lb-ft)
Install new cotter pin.
$
Apply SUZUKI SUPER GREASE to the steering shaft holders
and dust seals before remounting the steering shaft holders.
& 99000-25030: SUZUKI SUPER GREASE A (USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
$
Replace the removed cotter pin with a new one.
To prevent the entry of dirt, the dust seal end
A must
face forward when installed to the steering shaft.
PartShark.com
877-999-5686
To Next Page
Loading...
