3-8 ENGINE
ENGINE INSTALLATION
Remount the engine in the reverse order of engine removal.
Pay attention to the following points:
NOTE:
* The engine mounting nuts are self-locking.
* Once the nut has been removed, it is no longer of any use. Be
sure to use new nuts, and then tighten them to the specified
torque.
CLUTCH RELEASE ADJUSTMENT
Temporarily install the gear shift lever.
Remove the clutch adjuster cap.
Loosen the clutch release outer guide nuts
1.
Loosen the locknut
2.
Turn the adjusting screw
3 clockwise until it stops.
ITEM N•m kgf-m lb-ft
A
23 2.3 16.5
BCD
66 6.6 48.0
@
PartShark.com
877-999-5686
To Next Page
Loading...
