Suzuki LT-Z250 - Remounting

CHASSIS 7-65
 Remove the screw
7 and washers 8.
 Remove the knob
9.
 Disconnect the cable by removing the rotor
0.
REMOUNTING
Remount the reverse lock release cable in the reverse order of
removal. Pay attention to the following points:
 Install the spring so that the spring end
A matches the groove
B on the housing.
 Apply SUZUKI SUPER GREASE to the O-ring
1.
& 99000-25030: SUZUKI SUPER GREASE  A (USA)
99000-25010: SUZUKI SUPER GREASE  A (Others)
 Install the O-ring
1 to the reverse lock release cable 2.
 Connect the cable to the rotor
3 through the hole of the hous-
ing.
NOTE:
* When installing the rotor, hook the spring end
C on the con-
cave portion
D of the rotor.
* Make sure that the reverse lock release cable is routed cor-
rectly.
PartShark.com
877-999-5686