2-10 PERIODIC MAINTENANCE
ENGINE OIL AND OIL FILTER
The oil should be changed while the engine is warm. Oil filter
replacement should be done together with the engine oil change
at the intervals shown above.
ENGINE OIL REPLACEMENT
Place an oil pan under the engine oil drain plug
1, and then
drain out the engine oil by removing the engine oil drain plug
1 and engine oil filler cap
2.
Tighten the engine oil drain plug
1 to the specified torque,
and then pour new engine oil through the oil filler hole. When
performing an oil change (without oil filter replacement), the
engine will hold about 2.2 L (2.3 US qt, 1.9 lmp qt) of oil. Use
the engine oil that meets the API service classifications SF or
SG and that has the viscosity rating of SAE 10W-40.
# Engine oil drain plug: 21 N•m (2.1 kgf-m, 15.0 lb-ft)
Install the oil filler cap
2.
Start the engine and allow the engine to run for a few minutes
at idling speed.
Turn off the engine and wait about three minutes, and then
check the oil level on the dipstick
3. If the level is below
upper line, add oil to that level. The vehicle must be in a level
position for an accurate measurement.
OIL FILTER REPLACEMENT
Drain engine oil. (!Above)
Remove the oil filter cap
1.
Remove the oil filter and O-rings.
Replace initially at 1 month and every 6 months there-
after.
PartShark.com
877-999-5686
To Next Page
Loading...
