PERIODIC MAINTENANCE 2-13
CLUTCH
Remove the clutch adjuster cap
1.
NOTE:
Adjust the clutch release, when the engine is cold.
Loosen the locknut
2.
Tighten the adjusting screw
3 until it stops.
Loosen the adjusting screw
3 1/16 1 /8 turn.
Tighten the locknut
2 to the specified torque while holding
the adjusting screw
3.
# Locknut
2: 23 N•m (2.3 kgf-m, 16.5 lb-ft)
Apply engine oil to the O-ring and cap thread lightly.
Tighten the clutch adjuster cap to the specified torque.
# Clutch adjuster cap: 15 N•m (1.5 kgf-m, 11.0 lb-ft)
Adjust every 6 months.
PartShark.com
877-999-5686
To Next Page
Loading...
