4-16 DRIVE TRAIN
Install new C-rings by tapping with a copper hammer.
After reassembling the universal joint, check the joint move-
ment smoothly. If a large resistance is felt to movement, tap
the bearing with a plastic mallet lightly.
REAR DRIVE INSTALLATION
Install the rear drive in the reverse order of removal. Pay atten-
tion to the following points:
Coat new O-ring with SUZUKI SUPER GREASE and install it
into the groove in the gear case.
$ 99000-25030: SUZUKI SUPER GREASE A ( USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
Apply SUZUKI SUPER GREASE to the splines of the axle.
$ 99000-25030: SUZUKI SUPER GREASE A ( USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
Apply THREAD LOCK SUPER to the axle housing/final gear
case bolts, and tighten them to the specified torque.
) 99000-32030: THREAD LOCK SUPER 1303
% Axle housing/final gear case bolt:
65 N•m (6.5 kgf-m, 47.0 lb-ft)
PartShark.com
877-999-5686
To Next Page
Loading...
