Suzuki LT-Z250 - Page 133

DRIVE TRAIN 4-15
FINAL GEAR CASE COVER/GEAR CASE
[FINAL ASSEMBLY]
 Coat new O-ring with SUZUKI SUPER GREASE and apply
SUZUKI BOND to the mating surface of the cover, then install
the gear case cover.
$ 99000-25030: SUZUKI SUPER GREASE  A ( USA)
99000-25010: SUZUKI SUPER GREASE  A ( Others)
' 99104-31140: SUZUKI BOND  1207B (USA)
( 99000-31110: SUZUKI BOND  1215 (Others)
NOTE:
After the backlash and tooth contact have been checked or
adjusted (!4-18), install new O-ring and apply SUZUKI
BOND.
 Apply THREAD LOCK SUPER to the case cover bolts and
tighten them to the specified torque in a crisscross pattern.
) 99000-32030: THREAD LOCK SUPER  1303
% Gear case cover bolt: 26 N•m (2.6 kgf-m, 19.0 lb-ft)
NOTE:
After the backlash and tooth contact have been checked or
adjusted, apply THREAD LOCK SUPER to the case cover bolts.
UNIVERSAL JOINT
 Apply SUZUKI SUPER GREASE to the bearing and its dust
seal lip.
$ 99000-25030: SUZUKI SUPER GREASE  A ( USA)
99000-25010: SUZUKI SUPER GREASE  A ( Others)
 Install the universal joint and bearings with the special tool.
" 09913-70210: Bearing installer set
PartShark.com
877-999-5686