ELECTRICAL SYSTEM 8-19
INSPECTION
IGNITION COIL PRIMARY PEAK VOLTAGE
Disconnect the spark plug cap.
Connect a new spark plug to the spark plug cap and ground it
to the cylinder head.
NOTE:
Make sure that the spark plug cap and spark plug are connected
properly and the battery is fully-charged.
Measure the ignition coil primary peak volt using the multi circuit
tester in the following procedure:
Connect the multi circuit tester with the peak voltage adaptor
as follows.
+ Probe: Black/White lead wire
- Probe: White/Blue lead wire
NOTE:
Do not disconnect the ignition coil primary wire.
$ 09900-25008: Multi circuit tester set
"
Shift the transmission to the neutral position and turn the igni-
tion switch to the ON position.
Press the starter button and allow the engine to crank for a
few seconds, and then measure the ignition coil primary peak
voltage.
Repeat the above procedure a few times and measure the
highest ignition coil primary peak voltage.
# Ignition coil primary peak voltage: 120 V and more
( Tester knob indication: Voltage (& )
1
If the voltage is lower than the standard values, inspect the igni-
tion coil. (!8-20)
When using the multi circuit tester and peak volt adap-
tor, refer to the appropriate instruction manual.
While testing, do not touch the tester probes and
spark plug to prevent receiving an electric shock.
Peak volt adaptor
CDI
unit
Battery
New spark plug
Ignition
coil
PartShark.com
877-999-5686
To Next Page
Loading...
