8-18 ELECTRICAL SYSTEM
Step 3
1) Measure the ignition coil primary peak voltage. (!8-19)
NOTE:
This inspection method is applicable only with the multi circuit tester and the peak volt adaptor.
Is the peak voltage OK ?
Step 4
1) Inspect the spark plug. (!2-7)
Are the spark plug OK ?
Step 5
1) Inspect the ignition coil. (!8-20)
Are the ignition coil OK ?
Step 6
1) Measure the pickup coil peak voltage and its resistance. (!8-20 to -21)
NOTE:
The pickup coil peak voltage inspection is applicable only with the multi circuit tester and peak volt adaptor.
Are the peak voltage and its resistance OK ?
YES Go to Step 4.
NO Go to Step 5.
YES
Poor connection of the spark plug cap
Go to Step 5.
NO Faulty spark plug
YES Go to Step 6.
NO Faulty ignition coil
YES
Faulty CDI
Open circuit in wiring harness.
Poor connection of ignition couplers
NO Faulty pickup coil
PartShark.com
877-999-5686
To Next Page
Loading...
